FATC Replacement Procedure TITLE : FATC Replacement Procedure Doc No: 2921 02 217 A1198 Date: 3rd February 17 Revision: 1.0 Page: 6 of 9 Prepared : Valentina \Vinisha Checked: Valentina Approved: Anand Sikchi This specification is the exclusive property of Tata Motors Limited. Without their consent it may not be reproduced or given to third parties. The above specifications are subject to change and therefore suppliers are requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD. 3. FATC Replacement FATC’s replacement process is consistent across all trim levels. FATC that is replaced in place of a damaged one will be prior tested and in proper working condition. On connecting new FATC in vehicle, FATC should work without any issues once the calibration is done. 3.1. Replacement Process The FATC replacement process is done when FATC is damaged for various reasons. The FATC replacement process has two aspects as given below: 1. Mechanical 2. Electrical 3.1.1. Mechanical For mechanical replacement & assembly sequence, please refer “FATC Information Fitment Drawing”. 3.1.2. Electrical The electrical aspect of FATC replacement is to ensure that ECU is having the required SW. 1. Switch OFF the Ignition. 2. For Mechanical removal of the control panel, refer the “FATC Information Fitment Drawing”. 3. Remove both connectors (Vehicle side connector and HVAC side Connector) from ECU. 4. Replace with new ECU. 5. Assemble the ECU as per the assembly sequence instruction. Refer “FATC Information Fitment Drawing”. 6. Connect both (Vehicle side connector and HVAC side Connector) to the ECU. 7. Connect the Diagnostics tool to OBD connector. 8. IGN on condition and execute the “Actuator Motor Calibration Routine” Actuator Motor Calibration routine Step 1 - Start the Routine Start request: 31 01 3e 02
RkJQdWJsaXNoZXIy MTIwNTUz