PEPS Part ReplacementProcedure Title: PEPS System Part Replacement Procedure Spec Num 2921 XX XXX A XXXXTBD Date: 28-Jul-18 Version: 1.5 Page: 7 of 25 Prepared: Sandip Checked: Santosh B Approved: Dinesh DG Thisspeci fication is the exclusive property of Tata MotorsLimited. Wi thout their consent i t may not be reproduced or given to thi rd parties. The above speci ficationsare subject to change and therefore suppl iersare requested to refer the latest one. CONTROLLED COPY FOR RESTRICTED CIRCULATION © TATA MOTORS LTD. 1. Introduction 1.1. General The purpose of this document is to specify the PEPS ECU replacement procedure to be performed at service or dealer. It also specifies the smart key/ UID / wearable learning, addition or deletion (in case of loss) procedure at service or dealer. 1.2. Document Scope This document describes the PEPS ECU replacement procedure, smart key/ UID / wearable learning procedure, smart key / UID / wearable addition or deletion procedure (in case of key lost). The TML service team is the intended audience for this document. 1.3. Terminologies The following table describes the terminologies used in this document. Term/ Abbreviation Description DTC Diagnostics trouble code EOL End of Line ECU Electronic control unit IGN Ignition TML TATA Motors Ltd. OBD On board-Diagnostics PEPS Passive Entry Passive Start SPD Spare Part Department UID User identification device VC Vehicle Variant Code VIN Vehicle Identification Number
RkJQdWJsaXNoZXIy MTIwNTUz