Vehicle Platform: OSPREY ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 1.4 Date: 15 May 2018 Author: Body CoC Page: 576 of 855 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. B2213 - 92: Front Wiper Park Position Signal - Performance or incorrect operation Overview: ISO Code (DTC Code) B2213 - 92 Customer Symptom Front and rear wash/wipe may not function correctly Fault Effects (On Vehicle) Front and rear wash/wipe may not function correctly Lamp Status (If Any) NA Fault Detection Condition This fault will be logged when user operates the front wiper motor with front wiper is in park for more than preconfigured delay time due to failure in park input. If in-park fault is detected for Front wiper park position signal for more than defined delay then this DTC code will be returned with the results. Normal Operating Condition There should not be any fault returned when wiper motor is operated Probable Trouble Area 1. BCM connector Fault 2. Cockpit wiring harness short to ground 3. BCM ECU fault Healing Condition 1. Ignition OFF ON 2. Clear DTC Command Component Details: Front wiper Park Position Signal part of front wiper motor and interfaced to the BCM as a feedback input. If the IGN is on and if user put the combi switch to front wiper on position, front wiper park position signal gives a feedback to BCM about the in park and out of park of the front wiper. Preliminary Checks: Check Battery Voltage (9V-16V) Check ECU pins for oxidation, bending & damage. Trouble Shooting:-
RkJQdWJsaXNoZXIy MTIwNTUz