Vehicle Platform: OSPREY ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 1.4 Date: 15 May 2018 Author: Body CoC Page: 375 of 855 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting: B1306 - 11: Left Rear Door Ajar Switch - Circuit Short to Ground START Connect Diagnostic tool and Run Input Test Routine and operate the switches as mentioned in the input switch test routine specification. Is DTC B1306 – 11 logged by Routine? Disconnect vehicle battery connection. (Please follow the safety guidelines) Check connection between BCM and Rear Left door switch Are connectors loose? Correct connector fault (Terminals Bend) 1.Remove BCM Connector. 2.Perform visual check of connectors for pins bent or damaged Is connector faulty? STOP 1. Close all doors 2. Check continuity between BCM connector pin [C4-17] Harness side) with Ground [C1-34/C1-47] Continuity Found? 1. Remove Rear Left Door Switch mating connector 2.Perform visual check of connectors for pin bend or damaged Reconnect connectors firmly Connector Faulty? Correct Connector fault (Terminal Bend) NO YES YES NO YES YES YES NO NO NO Check if Rear Left door switch input[wiring harness side] is shorted to ground [C104-1]. Correct Rear Left door switch side wiring harness (Short to Ground) 1. Close and Open the Rear Left door 2. Check if Rear Left Door switch is operating? Is Rear Left Door switch is operating? Reconnect all connectors firmly NO YES Correct BCM side wiring harness ( Short to Ground) Continuity Found? YES NO NO Connect battery and other connectors of BCM ECU, if disconnected. BCM ECU Faulty Replace BCM ECU DTC’s confirmation: After rectification, ensure the following points by using TML diagnostic tool before handing over to customer.
RkJQdWJsaXNoZXIy MTIwNTUz