Vehicle Platform: OSPREY ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 1.4 Date: 15 May 2018 Author: Body CoC Page: 323 of 855 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. B222D - 11: Low Beam Switch - Circuit Short to Ground Overview: ISO Code (DTC Code) B222D - 11 Customer Symptom Low beam always ON Fault Effects (On Vehicle) 1. Low beam always ON 2. Battery Drain Lamp Status (If Any) Continuous ON Fault Detection Condition This fault will be logged after the input switch test routine execution. User has to operate the switch manually during routine. If short to ground fault is detected for low beam switch then this DTC code will be returned with the Routine results. Normal Operating Condition There should not be any fault returned by routine Probable Trouble Area 1. BCM connector Fault 2. Low beam switch input short to ground from Cockpit wiring harness 3. Low beam switch damaged or stuck 4. Combi switch connector fault. 5. BCM ECU fault Healing Condition 1. Ignition OFF ON 2. Clear DTC Command Component Details: Low beam switch is part of combination stalk switch and interfaced to the BCM. If the IGN is on and headlamps are ON and if the combi switch is at low beam position then low beams will turn ON. Preliminary Checks: 1. Check Battery Voltage (12.5 V and above) 2. Check ECU pins for oxidation, bending & damage. Trouble Shooting:-
RkJQdWJsaXNoZXIy MTIwNTUz