Vehicle Platform: OSPREY ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 1.4 Date: 15 May 2018 Author: Body CoC Page: 271 of 855 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. B222E - 12: Main Beam Switch - Circuit short to Battery or Open Circuit Overview: ISO Code B222E - 12 Customer Symptom Main beam always OFF Fault Effects (On Vehicle) Main beam always OFF Lamp Status (If Any) Always OFF Fault Detection Condition This fault will be logged after the input switch test routine execution. User has to operate the switch manually during routine. If short to battery or open circuit fault is detected for main beam switch then this DTC code will be returned with the Routine results. Normal Operating Condition There should not be any fault returned by routine Probable Trouble Area 1. BCM connector Fault 2. Main beam switch input Short to battery or open circuit from cockpit wiring harness 3. Switch damaged or stuck 4. Combi switch connector fault. 5. BCM ECU fault Healing Condition 1. Ignition OFF ON 2. Clear DTC Command Component Details: Main beam switch is part of combination stalk switch and interfaced to the BCM. If the IGN is on and headlamps are ON and if user put the combi switch to main beam position, high beams will turn ON. Preliminary Checks: 1. Check Battery Voltage (12.5 V & above) 2. Check ECU pins for oxidation, bending & damage. Trouble Shooting:-
RkJQdWJsaXNoZXIy MTIwNTUz