Q501 4 Cylinder MT Application DTC Troubleshooting Data Version: 0.1 Date: 21-Sep-2018 Prepared By: Mithi Prasad, Sarang Kulkarni, Manish Gupta Checked By: Yogesh Jadhav Approved By: Satish Kumar P Page: 172 of 1052 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P1218 - 92: Recovery hardware of Control Unit (Control Unit reset) - Performance or Incorrect Operation Overview: DTC Description as per ISO standard Recovery hardware of Control Unit (Control Unit reset)- Performance or Incorrect Operation ECU Pin Number - Customer Symptom - Fault Effects (On Vehicle) Vehicle may not start Lamp Status (If Any) - Fault Detection Condition (Root cause) Ignition ON Normal Operating Condition Fault condition no more present Probable Trouble Area EMS ECU Healing Condition 1. Run the diagnostic procedures to check the ECU Power & ground. 2. Check the integrity of the ECU pins of the ECU, if the fault still occurs, replace the ECU and reprogram the controller Component Details: EMS ECU is an electronic controller which controls the Engine functionality by interfacing with various sensors, actuators and other controllers (via CAN). Preliminary Checks: 1. Check whether the customer voice / view about the issue is matching with the fault effects mentioned above. 2. If yes, go ahead with next steps. If not, check for other DTC’s presence. 3. Check whether similar complaints are earlier reported. If yes, perform the preliminary checks with respect to 4. Earlier issue closure. Check for pin back out at EMS ecu connector or EGR valve connector. 5. Check whether the EMS is receiving Battery supply and Ground 6. Check whether the Battery is healthy.
RkJQdWJsaXNoZXIy MTIwNTUz