Q5 Project –EMS ECU/Component Replacement Procedure Q5 Project – EMS ECU/ Component Replacement Procedure Doc No: 2921 02 224 A1730 Date: 24 July 2017 Revision: 0.1 Page 12 of 26 Prepared: Shashank Addala / Prasad M Checked: Prasad M Approved: Satishkumar P This document contains confidential information which is exclusive property of TML. The contents of this document shall not be reproduced, or conveyed, or given to third parties in any manner without the consent of TML. Step 9: Engine Oil to be replaced with new Oil Step 10: “Reset of Blinking Engine Oil Pressure Lamp” IOCP Execution Detail: Refer Section 3.9 in ‘TML_PT_Q5_IOCP_EMS Requirement_2921 02 224 A1725_24June2017_V0.2’ document Engine oil parameters reset routine set to following parameters: - RDI 380C - Number of automatic reset procedure (Olil life reset with Examiner): it is increased of 1, - RDI 380D - Number of manual reset procedure (Oil life reset with manual procedure): it does not change, - RDI 380E - Odometer value at last automatic reset procedure (Olil life reset with Examiner): it is set to RDI 2001/RLI 03 value, - RDI 380F - Odometer value at last manual reset procedure (Oil life reset with manual procedure): it does not change , - RDI 3811 - Odometer value at the starting of change oil required indication: it does not change, - RDI 3810 - Remaining distance at exaust oil: it is set to MaxDistT calibrated value, - RDI 3813 - Remaining percentage at exaust oil: it is set to 100% value, - RDI 3818 - Oil life remaining from distance information: it is set to 100% value, - RDI 381A - Oil life remaining from oil exhaust information: it is set to 100% value, - RDI 381B - Oil life remaining from module coolant temperature and crankshaft revolutions: it is set to 100% value. [Note: Perform Ignition toggle (Ignition OFF and Ignition ON) once procedure is completed in EMS ECU.]
RkJQdWJsaXNoZXIy MTIwNTUz