Vehicle Platform: Tiago,Tigor & Osprey ECU Name: Hella Body Control Module (BCM) DTC Troubleshooting Data Version: 2.0 Date: 22-10-2018 Author: Parag K Page: 350 of 737 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. START Connect Diagnostic tool and Run Input Test Routine and operate the switches as mentioned in the input switch test routine specification. Is DTC B130D – 12 logged by Routine? Disconnect vehicle battery connection. (Please follow the safety guidelines) Check BCM and Rear Right door switch connectors for terminal backout Are connectors loose? 1.Remove BCM Connector. 2.Perform visual check of connectors for pins bent or damaged. Is connector faulty? Check continuity between BCM connector pin [ C4-5] Harness side) with battery [C3-2/C3-1] Continuity Found? 1. Remove Rear Right door switch 2. Check continuity between BCM harness side connector pin [C4-5] and Rear Right door switch [C105-1] STOP YES NO YES NO Reconnect connectors firmly Correct connector fault (Terminals Bend) YES NO Correct BCM Side wiring harness (Short to Battery) NO YES B130D - 12: Right Rear Door Ajar Switch - Circuit short to Battery or Open Circuit Open Circuit? Perform the visual check of connectors for pin bend or damaged Is connector faulty? Check continuity at Rear Right door switch [C105-1] with ground [C1-34/C1-47] Continuity found? BCM ECU Faulty Correct wiring harness (Open Circuit) YES NO Correct connector fault (Terminal Bend) Correct connector fault at Rear Right door switch mating connector (Open Circuit) YES NO YES NO Replace BCM ECU Continuity found? YES NO 1. Switch is faulty 2. Replace Rear Right Door switch Check continuity between two terminals of Rear Right door switch
RkJQdWJsaXNoZXIy MTIwNTUz