Q5 Project –EMS ECU/Component Replacement Procedure Q5 Project – EMS ECU/ Component Replacement Procedure Doc No: 2921 02 224 A1730 Date: 24 July 2017 Revision: 0.1 Page 6 of 26 Prepared: Shashank Addala / Prasad M Checked: Prasad M Approved: Satishkumar P This document contains confidential information which is exclusive property of TML. The contents of this document shall not be reproduced, or conveyed, or given to third parties in any manner without the consent of TML. 1 Introduction This document contains the Procedures sequence to perform in case of component substitution or in case of configuration functions, i.e. the process to be followed whenever an ECU to be replaced or reflashed with new ECU software version or new software calibration version. 1.1 General Overview This document, will guide the service person/technician to correctly follow the steps in case of ECU/component replacement. It will also avoid the situation where vehicle failed to start due to the wrong procedure followed by technician. 1.2 Scope of the Document The scope of this document is limited to define the Component Replacement Procedure requirement. 1.3 Intended Audience The function owners, E&E CoC and ECM supplier are primary audience of this document. 1.4 IPR Ownership All Intellectual Property Rights that are directly or indirectly related to this document shall rest with CoC PT and related TML Internal Departments. 1.5 Reference Documents S No. Document Name Document No. Version No. Release Date - - - - - 2 Project Applicability The requirements specified in this document are applicable for all the MT variants of Q5 project which include Q501 which is a 5-seater application and Q502 which is a 7-seater application.
RkJQdWJsaXNoZXIy MTIwNTUz