Q501 4 Cylinder MT Application DTC Troubleshooting Data Version: 0.1 Date: 21-Sep-2018 Prepared By: Mithi Prasad, Sarang Kulkarni, Manish Gupta Checked By: Yogesh Jadhav Approved By: Satish Kumar P Page: 74 of 1052 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Step Checks IF YES IF NO 1. Read IVN DTCs in ECM. Is buss off in ECM in current state? 1. Remove ECM from vehicle wiring harness. 2.Measure the resistance between following lines in ECM vehicle side wiring harness 1. CANH &CANL, 2. CANH & Ground , 3. CANL & Battery, 4. CANH &Battery, 5. CANL &Ground Go to step 2. Clear DTC. 2. Is Resistance R < 10 ohm. There is short circuit failure in between respective two lines. Do necessary repair in the harness. Clear DTC. Check the resistance between CANH and CANL of ECM connector in vehicle wiring harness.(with IPC connected on the vehicle).Go to step 3. 3. Check the resistance between CANH and CANL of ECM connector in vehicle wiring harness.(with IPC connected on the vehicle). Is resistance ≠ 120 ohm ? Check the continuity between 1. ECM CAN_H & IPC CAN_H 2. ECM CAN_L & IPC CAN_L In vehicle side connectors. Do necessary repair in the Harness. Go to step 4. Clear DTC. 4. If fault still persists. then replace sensor and if fault still persists then call Hotline. Follow the above procedure again for Reconfirmation. DTC’s confirmation (checks before handing over vehicle to customer):
RkJQdWJsaXNoZXIy MTIwNTUz