274 ENGINE 273 MPFI Sr. No. Sensor/Actuator Storage Tightening Installation / Handling / Temperature Torque Storage Instructions 5 IACV (-40 ºC to 140 ºC) - 1. When replacing IACV, new O-ring seal & thread locked screws must be assembled instead of the original one (Tightening torque 4-5 Nm) 2. Pintle position can not guaranteed during the exchange operation, if needed the pintle position must be set using specific driver. 6 MAP Sensor (DSS3TF) As a part of Throttle Body. - 1. Maximum permissible pressure at mounting flange 20 N/sq.mm. 2. It should be stored in dry and clean place. 3. Should be mounted to a plane surface on the intake manifold, the pressure neck and the temperature sensor project into the intake –mani fold and are sealed to atmosphere by an O-ring. 4. Ensure that the O-ring is not damaged at assembly, a thin film of oil can be applied on O-ring before assembly. 5. Use water proof harness connector for protection against water ingress. 6. Admissible bending radius of the cable up to the first cable mounting point R>50 mm. 1. In case of removal & reinstallation of the injector O-Rings must be replaced. 2. Damage to the sealing surfaces of the injector must be avoided. 3. Maximum time of storage is 1 year. 4. Permissible fuels: Unleaded and leaded gasoline’s per DIN 51600 and DIN EN 228. 5. Lubricate both O-rings circumferential with clean non-silicon motor oil. 6. Maximum injector temperature in the vehicle (not operated): +140ºC. 7. Avoid intrusion of foreign material and contamination during assembly. 8. Do not remove the O-ring supporting disk from the injector. 9. Do not contaminate the injector, inside and orifice holes from Lubricating oil. 10. Maximum 2 deg deviation is allowed between injector axis and the fuel rail outlet, respectively to the intake manifold. 11. Attention should be paid in particular to the inlet tube, O-rings, injector spray end (spray pintel, director plate, protection cap) and electrical connector. - (-40 ºC to 130 ºC) Fuel Injector (EV6) 7
RkJQdWJsaXNoZXIy MTIwNTUz