Automated Manual Transmission 54 3. Pre-load the sensor’s Sensor, rotating clockwise until fixing holes (1a) and (1b) are aligned. 4. Tighten the screws fixing the electrohydraulic selection gearbox gear engagement position sensor to the prescribed torque. Component Fixing Value (Nm) Gear engagement position sensor Screw 3 – 4.2 5. Fit hydraulic speed selection hydraulic actuator unit and clutch 6. Fit wiring for manual gearbox hydraulic selection system on hydraulic selection unit 7. Fit protection/guard under engine. 8. Refill the electro-hydraulic selection gearbox hydraulic control system, with reference to 9. Check level of hydraulic system fluid for gearbox with hydraulic selection and top up, if necessary. 10. Fit battery support/drip tray. 11. Fit battery. 12. Connect the diagnosis equipment and carry out the following operations: Bleed air of hydraulic system for gearbox with hydraulic selection Clutch self-calibration enablement. Grid self tuning - service. New actuators (only if the hydraulic actuation unit is being replaced). Remove the car from the lift.
RkJQdWJsaXNoZXIy MTIwNTUz