Automated Manual Transmission 47 Odd and Even Gear Engagement Solenoids Removal: 1. Place the car on a lift. 2. Position the gear lever at N. 3. Connect the diagnosis equipment and carry out the accumulator depressurization procedure. 4. Remove protection/guard under engine 5. Remove left front wheel. 6. Remove battery. 7. Remove battery support/drip tray. 8. Remove wiring for manual gearbox hydraulic selection system on hydraulic selection unit 9. Remove hydraulic speed selection hydraulic actuator unit and clutch 10. Loosen and remove the fixing screws for the odd gear engagement solenoid valve. 11. Remove the odd gear engagement solenoid valve (1a) complete with O-rings (1b). 12. Remove the O-ring from the odd gear engagement solenoid valve seat. 13. Proceed in the same way to remove the even gear engagement solenoid valve. Odd and Even Gear Engagement Solenoids Fitment: 1. Fit a new O-ring in the odd gear engagement solenoid valve seat. 2. Place the odd gear engagement solenoid valve in its seat complete with new Orings and tighten the screws to the prescribed torque. 3. Proceed in the same way for the even gear engagement solenoid valve. Component Fixing value (Nm) Odd and even gear engagement solenoid valves Screw 3 – 4.2 4. Fit hydraulic speed selection hydraulic actuator unit and clutch 5. Fit wiring for manual gearbox hydraulic selection system on hydraulic selection unit 6. Fit left front wheel
RkJQdWJsaXNoZXIy MTIwNTUz