Automated Manual Transmission 48 7. Fit protection/guard under engine 8. Refill the electro-hydraulic selection gearbox hydraulic control system, with reference to 9. Check level of hydraulic system fluid for gearbox with hydraulic selection and top up, if necessary. 10. Fit battery support/drip tray. 11. Fit battery. 12. Connect the diagnosis equipment and carry out the following operations: Bleed air of hydraulic system for gearbox with hydraulic selection Clutch self-calibration enablement. Grid self tuning - service. New actuators (only if the hydraulic actuation unit is being replaced). Remove the car from the lift. Gear Selection Solenoids Removal: 1. Place the car on a lift. 2. Position the gear lever at N. 3. Connect the diagnosis equipment and carry out the accumulator depressurization procedure. 4. Remove protection/guard under engine. 5. Remove battery. 6. Remove battery support/drip tray. 7. Remove wiring for manual gearbox hydraulic selection system on hydraulic selection unit 8. Remove hydraulic speed selection hydraulic actuator unit and clutch. 9. Loosen and remove the screws (1a) and remove the 1st and 2nd gear selection solenoid valve (1b) complete with O-rings (1c).
RkJQdWJsaXNoZXIy MTIwNTUz