Automated Manual Transmission 46 Pipe from Clutch Master Cylinder to Clutch Release Actuator Removal: 1. Connect the diagnosis equipment and carry out the accumulator depressurization procedure. 2. Remove battery. 3. Remove battery support/drip tray. 4. Raise the clip and disconnect the pipe from clutch master cylinder to clutch release actuator, actuator side. 5. Raise the clip and disconnect the pipe from clutch master cylinder to clutch release actuator, master cylinder side. 6. Remove the pipe from clutch master cylinder to clutch release actuator (2a) complete with O-rings (2b). Pipe from Clutch Master Cylinder To Clutch Release Actuator Fitment: 1. Place the pipe from clutch master cylinder to clutch release actuator in its housing complete with new O-rings and engage the retaining clips. 2. Refill the electro-hydraulic selection gearbox hydraulic control system, with reference to 3. Check level of hydraulic system fluid for gearbox with hydraulic selection and top up, if necessary 4. Fit battery support/drip tray. 5. Fit battery. 6. Connect the diagnosis equipment and carry out the following operations: Bleed air of hydraulic system for gearbox with hydraulic selection Clutch self-calibration enablement. Grid self tuning - service. New actuators (only if the hydraulic actuation unit is being replaced).
RkJQdWJsaXNoZXIy MTIwNTUz