ENGINE 1.3L QUADRAJET (90PS) 65 Exhaust (4a) on the piston skirt which should be aligned with the oil jet (4b). 6. Fit the calibrated wire (plastic gage) (1) for measuring the bearing clearance. 7. Refit the connecting rod cap assemblies (1a) in their seats with upper connecting rod bearing halves using tool (1b). Check one journal at a time, without rotating the crankshaft. upper connecting rod bearing half, connecting rod side trimetallic and dark in colour- lower connecting rod bearing half, cap side bimetallic, light coloured with a hole Never reverse the positioning of the connecting rod bearing halves under any circumstances. 8. Tighten the connecting rod cap M8 bolts (2a) to the recommended torque of 1.9 ~ 2.1 kg-m and a tighten using the angular tightening tool (2b) to 40° +/- 2°. 9. Remove the bolts and remove the connecting rod caps with the half-bearings fitted previously. 4. Refit the piston-connecting rod assemblies (1a) in their seats with upper connecting rod bearing halves using tool (1b). NOTE : Q The connecting rod bearing halvesmay be identified as follows: Q upper connecting rod bearing half, connecting rod side, trimetallic and dark in colour; Q lower connecting rod bearing half, cap side bimetallic, light coloured with a hole. Q Never reverse the positioning of the connecting rod bearing halves under any circumstances. 5. Rotate the engine through 180º on the overhauled stand.
RkJQdWJsaXNoZXIy MTIwNTUz