ENGINE 1.3L QUADRAJET (90PS) 64 CLASSIFICATIONANDALLOCATIONOF THRUST WASHERS The selection of thrust washers for the centre main journal should be made using reference 3 in the diagram (i.e. R for the normal size, RM for a 0.127 mm oversize), therefore the selection should be made using the crankshaft end float measured previously. Half ring grade Thickness grade R (normal ) 2.310 - 2.360 mm grade RM (0.127 mm oversize) 2.437 - 2.487 mm 3A.1.2.3.5 ENGINE BLOCK – ASSEMBLY NOTE : Piston grade code located at (1) may be: A - B - C or AM - BM - CM for oversize pistons. The arrow (2) shows the timing side. Area where the number of the matching cylinder liner is stamped and is indicated by (3) in the fig. above. 1. Fit the tool (1) 287158900628 (Flange). 2. Turn the crankshaft using the tool fitted previously. 3. Fit the connecting rod-piston assemblies and align in accordance with the following references.
RkJQdWJsaXNoZXIy MTIwNTUz