TIGOR EV SERVICE MANUAL

SUSPENSION 31  INSTALLATION: 1. Follow the above steps in reverse order in ap- propriate sequence for its assembly. NOTE:  If the disc surface is uneven showing rough marks, grooves - machine it to the specified limit; measure the run out on dia 220 w.r.t. hub and disc resting face.  Punch mark around bolt hole where run out on dia 220 is at low point.  Align low point on disc and high point on hub while assembly. Assemble with countersunk screws. 2. Tighten drive shaft nut 23 to 26 kg.m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft.  PRECAUTION: Use a new hub bearing and new circlip.  SUB ASSEMBLY - KNUCKLE / HUB: Clean all the parts thoroughly and replace damage / worn out parts. 1.With the help of drift (1) part No. 2779 5890 3301 and handle (2) part No.2640 5890 3511 fit bear- ing (3) in the knuckle. 2.Fit the circlip in knuckle. 3.Place the knuckle assembly over the hub. Using drift part No. 2576 5890 4401 press the knuckle assembly on the hub.