SAFARI BSVI SERVICE MANUAL

KRYOTEC ENGINE 88 59. Remove the hydraulic crane and sling form the lifting brackets. B. ENGINE FITMENT 1. Install the powertrain in the engine compartment using a hydraulic crane and 1871001700 Sling connected to the lifting brackets. 2. Install the left engine mount isolator and tighten the bolts (1a) and (1b) to the proper (Torque Specifications). 3. Install the support bracket (2) with the bolt tightened to the proper (Torque Specifications). 4. Install the right engine mount isolator and tighten the bolts (1a) and (1b) to the proper (Torque Specifications). 5. Remove the hydraulic crane and sling connected to the powertrain lifting brackets. 6. Install the fuel line retaining bracket with the screw tightened to the proper (Torque Specifications). 7. Connect the fuel supply line quick coupling. 8. Connect the fuel tank return line quick coupling. 9. Connect the engine wire harness connector and engage the wiring to the spring retainer. 10. Connect the Powertrain Control Module (PCM) wire harness connector and close the retaining clip. 11. Install the starter cable to the positive battery terminal and tighten the nut to the proper (Torque Specifications). 12. Pull back the lock sliders and engage the gear selector cables to the brackets. 13. Open the retaining clips and engage the gear selector cables to the lever arms. 14. Install the DPF differential pressure sensor with the nut tightened to the proper (Torque Specifications). 15. Connect the DPF differential pressure sensor wire harness connector. 16. Connect the glow plug control unit wire harness connector. 17. Install the pressurized coolant bottle and connect the quick coupling. 18. Install the degas hose to the thermostat and tighten the clamp to the proper (Torque Specifications). 19. Install the air delivery pipe to the throttle body with the screws tightened to the proper (Torque Specifications). 20. Secure the air delivery pipe to the support bracket with the screw tightened to the proper (Torque Specifications). 21. Install the vacuum hose to the vacuum pump and connect the quick coupling. 22. Connect the heater core hose quick couplings. 23. Connect the hose to the clutch slave cylinder and engage the retaining clip. 24. Connect the coolant hose quick couplings. 25. Install the battery ground cable with the bolt tightened to the proper (Torque Specifications). 26. Connect the reverse lamp switch wire harness connector. 27. Install the left and right half shafts (Refer to 03 - Differential and Driveline/Half Shaft/Removal and Installation).