SAFARI BSVI SERVICE MANUAL

ELECTRICAL 173 REFITMENT NOTE: New rain light sensor come is to be fitted with three-pole connector facing in upward direction without removing its plastic protective cap. 1. Remove the plastic protective cap from the new sensor. NOTE:  Do not touch the Silgel area.  The transparent protecting cap on the rain light sensor should be held lightly on it two handling surfaces to remove it. 2. Insert the sensor into the ring. Give gentle pressure (Max. 30N) on rain light sensor. NOTE:  To avoid the a dust deposit on the silgel after removing the transparent protective cap the rain light sensor must be placed immediately into the securing ring of the windscreen.  Remove ring protection cover from windscreen. The contact surface between rain light sensor & windscreen must be free from pollution as well as dust & dirt.  To avoid the air bubbles as much as possible between the silgel & windscreen, the sensor should be place into the securing ring so that the silgel can only touch at one points of its outside diameter to the windscreen. Therefore, choose the opposing side of the connector socket. 3. Snap the metal clip on holder to hold sensor tightly. 4. Connect the electrical connector of rain light sensor. 6. Fit the rain light sensor cover on windscreen.