TIGOR

1.05L REVOTORQ ENGINE 103 5. Loosen and remove the 6 mounting nuts. 6. Lift the in-tank pump carefully out NOTE  The fuel module shall consist of level sensor, sealing ring and locking ring.  The material of the FSU seal shall be HNBR as per SS:5565  Pump should have a flexibility in orientation atleast for two positions.  Electrical cables and hoses connecting pumps and flange should not be protrude outside the diameter.  The float orientation to be decided by party for better performance.  Be free from flash, Flaw, Rust and Concave on joining and sealing surface.  Be free from foreign body in fuel passage. ASSEMBLY  Don't hold the fuel pump unit by tubes, wires, fuel level sensor unit.  Remove the protection cap only before assembly of the hydraulic connector.  The fuel pump unit only has to be fixed at the outer diameter of the tank flange during assembly into fuel tank.  During transport of the tank with assembled fuel pump unit. It is absolutely necessary to protect the tubes with protective caps against dirt, particles etc.  Return line of vehicle has to be clean.  Hydraulic protection cap : Protection only against dust and splash water CONDITION OF USE  Minimum tank filling height for start of the engine after first filling equal to 25 mm from bottom of reservoir. (Only valid for horizontal tank bottom) E. Fuel Level Sensor : Removal : 1. Remove the tank unit. 2. Disconnect the connector. 3. Remove the fuel level sensor by releasing the snaps. Fuel Level Sensor Specification : Vehicle operating voltage : 12V DC with -ve ground Operating voltage : 8V to 16V