NANO

604 ELECTRICAL 11. Before removing a faulty component, refer to the WorkshopManual for removal procedures. Ensure the starter switch is turned to the ’OFF’ position, the battery is disconnected and any disconnected harnesses are supported to avoid any undue strain at terminals. When replacing the component keep oily hands away from electrical connection areas and push connector’s home until any locking tabs fully engage. 12.Battery charging Recharge the battery out of the vehicle and keep the top well ventilated. While being charged or discharged, and for approximately fifteen minutes afterwards, batteries emit hydrogen gas. This gas is inflammable. Always ensure any battery charging area is well ventilated and that every precaution is taken to avoid naked flames and sparks. c. Remove connectors which have catches by pressing in the direction indicated by arrows in the illustration. d. Connect connectors which have catches by inserting the connectors until a “snap” noise is heard. e. Dirt / corroded terminals result in improper contact. The terminals should be cleaned carefully. Improper ontact pressure between mating terminals disturbs the connectivity between them. Replace the damaged connector body to avoid exposure of the terminals in case of in adequate contact pressure. Ensure proper connection between the terminals to the wire. Rectify the loose connection by repairing / replacing the wire harness. Worn out insulation of the wire may result in short circuit Avoid water entering in the connectors.