NANO

DRIVETRAIN 377 DRIVETRAIN C. ASSEMBLY 1. Place the layshaft upright and fit the inner bearing race unto it in the front half side of the shaft using a suitable 2702 5890 35 04 (Drift for rear hub inner bearing outer race), . 2. Place the synchro cone on the First gear as shown in fig, with the projection on cone facing upwards and measure the gap between synchro cone and first gear using a feeler gauge. This gap should be within 1.15 ~1.40 mm. 3. Remove the synchro cone from the first gear; place the first gear on the lay shaft and fit the circlip in the slot. 4. Check the gap between the circlip and the first gear, it should be within 0.2 ~ 0.4 mm. 5. Now place the synchro cone on the first gear with the projection on cone facing upwards.