NANO

DRIVETRAIN 373 DRIVETRAIN 7. Place the synchro cone on the fourth gear and measure the gap. It should be between 1.15 ~1.40 mm. 8. Place the synchro cone and then place the fourth gear on it. 9. Place the spacer (input Shaft) on the fourth gear. 10. Fit the rear end ball bearing using the tool 2702 5890 35 04 (Drift for rear hub inner bearing outer race), such that the snap ring groove is uncovered. 11. Measure the axial float using a dial gauge; float should be within 0.2 ~ 0.4mm. 12. Fit the snap ring using a suitable drift