NEXON

CLUTCH 26 3. Overhauling of clutch cover assembly is not recommended. Before fitment, assembly should be checked against specification and for damage to pressure plate assembly. 4. Ensure that the clutch lining material is not contaminated with oil or grease as this shall result in clutch slipping. NOTE  It is must to replace clutch disc with cover assembly as a set for any of the above mentioned defects.  Also it is must to replace the concentric slave cylinder assembly as a whole with throw out bearing if the bearing is damaged or worn out. 5. Check the bearing for damage or abnormal noise. CAUTION Ensure that the clutch facing material is not contaminated with oil or grease as this shall result in clutch slipping. D. CLUTCH MASTER CYLINDER REMOVAL 1. Disconnect the battery connections. 2. Remove the splash guard and drain the clutch fluid from the hydraulic adapter. (For procedure refer clutch fluid draining procedure in this section.) 3. Pull out the clip using a screw driver and disconnect the high pressure line from clutch master cylinder by pulling it out. NOTE After disconnecting the high pressure line, plug the CMC opening with suitable cap to avoid entry of any contaminants. 4. Disconnect the hose connecting clutch master cylinder by removing the clamp. NOTE: Collect the fluid from the fluid reservoir in a clean container. OR Ensure that fluid does not fall from the hose.