ZEST BOLT Service Manual

Automated Manual Transmission 52 3. Pre-load the sensor’s Sensor, rotating clockwise until the fixing holes are aligned. 4. Tighten the screws fixing the electro- hydraulic selection gearbox gear selection position sensor to the prescribed torque. Component Fixing value (Nm) Gear selection position sensor Screw 3 – 4.2 5. Fit hydraulic speed selection hydraulic ac- tuator unit and clutch 6. Fit wiring for manual gearbox hydraulic selection system on hydraulic selection unit 7. Fit protection/guard under engine. 8. Refill the electro-hydraulic selection gear- box hydraulic control system, with reference to 9. Check level of hydraulic system fluid for gearbox with hydraulic selection and top up, if necessary. 10. Fit battery support/drip tray. 11. Fit battery. 12. Connect the diagnosis equipment and carry out the following operations:  Bleed air of hydraulic system for gearbox with hydraulic selection  Clutch self-calibration enablement.  Grid self tuning - service.  New actuators (only if the hydraulic actu- ation unit is being replaced).  Remove the car from the lift.