ZEST BOLT Service Manual

Automated Manual Transmission 51 carry out the following operations:  Bleed air of hydraulic system for gearbox with hydraulic selection  Clutch self-calibration enablement.  Grid self tuning - service.  New actuators (only if the hydraulic actu- ation unit is being replaced).  Remove the car from the lift. Hydraulic Selection Gearbox Speed Selection Position Sensor Removal 1. Place the car on a lift. 2. Position the gear lever at N. 3. Connect the diagnosis equipment and car- ry out the accumulator depressurization procedure. 4. Remove protection/guard under engine. 5. Remove battery. 6. Remove battery support/drip tray. 7. Remove wiring for manual gearbox hy- draulic selection system on hydraulic selection unit 8. Remove hydraulic speed selection hydrau- lic actuator unit and clutch. 9. Loosen and remove the screws and re- move the electro-hydraulic selection gearbox gear selection position sensor. 10. Remove the driver complete with O-ring. Hydraulic Selection Gearbox Speed Selection Position Sensor Fitment 1. Place the driver (1a) back in its housing, complete with O-ring, taking care to at- tach the pin (1b) with the fork (1c). 2. Place the electro-hydraulic selection gear- box gear selection position sensor (1a) back in its housing, inserting the driver pin (1b) in the Sensor (1c).