ZEST BOLT Service Manual

Automated Manual Transmission 48 7. Fit protection/guard under engine 8. Refill the electro-hydraulic selection gear- box hydraulic control system, with reference to 9. Check level of hydraulic system fluid for gearbox with hydraulic selection and top up, if necessary. 10. Fit battery support/drip tray. 11. Fit battery. 12. Connect the diagnosis equipment and carry out the following operations:  Bleed air of hydraulic system for gearbox with hydraulic selection  Clutch self-calibration enablement.  Grid self tuning - service.  New actuators (only if the hydraulic actu- ation unit is being replaced).  Remove the car from the lift. Gear Selection Solenoids Removal: 1. Place the car on a lift. 2. Position the gear lever at N. 3. Connect the diagnosis equipment and car- ry out the accumulator depressurization procedure. 4. Remove protection/guard under engine. 5. Remove battery. 6. Remove battery support/drip tray. 7. Remove wiring for manual gearbox hy- draulic selection system on hydraulic selection unit 8. Remove hydraulic speed selection hydrau- lic actuator unit and clutch. 9. Loosen and remove the screws (1a) and remove the 1st and 2nd gear selection so- lenoid valve (1b) complete with O-rings (1c).