ZEST BOLT Service Manual

Automated Manual Transmission 46 Pipe from Clutch Master Cylinder to Clutch Release Actuator Removal: 1. Connect the diagnosis equipment and car- ry out the accumulator depressurization procedure. 2. Remove battery. 3. Remove battery support/drip tray. 4. Raise the clip and disconnect the pipe from clutch master cylinder to clutch re- lease actuator, actuator side. 5. Raise the clip and disconnect the pipe from clutch master cylinder to clutch re- lease actuator, master cylinder side. 6. Remove the pipe from clutch master cyl- inder to clutch release actuator (2a) complete with O-rings (2b). Pipe from Clutch Master Cylinder To Clutch Release Actuator Fitment: 1. Place the pipe from clutch master cylinder to clutch release actuator in its housing complete with new O-rings and engage the retaining clips. 2. Refill the electro-hydraulic selection gear- box hydraulic control system, with reference to 3. Check level of hydraulic system fluid for gearbox with hydraulic selection and top up, if necessary 4. Fit battery support/drip tray. 5. Fit battery. 6. Connect the diagnosis equipment and car- ry out the following operations:  Bleed air of hydraulic system for gearbox with hydraulic selection  Clutch self-calibration enablement.  Grid self tuning - service.  New actuators (only if the hydraulic actu- ation unit is being replaced).