HEXA

FRONT AXLE (4X2) 6 INSPECTION NOTE Do not grease the unitised bearing as it is pre- greased for life. Check the condition of the following for wear or damage. If necessary replace with new one. 1. Check the condition of hub for wear / scoring marks. If necessary replace with new hub. 2. Check the condition of wheel bolts for worn out /stripped threads. Replace the bolts if necessary. Bolts are press fitted into the hub. 3. Check the condition of hex nut for stripped or worn out threads. Replace with new one if required. 4. Check the condition of the upper and lower wishbone ball joints. Check for excessive play in ball joints. If required replace with new one. (For procedure refer suspension section) 5. Check the condition of ball joints of tie rods and ARB link. If necessary replace with new one. 6. Check brake disc for scoring marks and measure disc size. Replace with new one if found undersize. (For procedure refer Brakes section) INSTALLATION 1. Make sure all parts are clean and free from dust. 2. Connect lower wishbone ball joint. (For procedure refer Suspension lower wishbone ball joint installation section) 3. Connect upper wishbone ball joint. (For procedure refer Suspension upper wishbone ball joint installation section) 4. Reconnect steering rack and pinion OBJ end to stub axle and tighten hex nut to 7 - 8 Kgm torque 5. Reconnect ARB link to stub axle and tighten the nut to 8 - 10 Kgm torque.