HEXA

GEAR BOX 21 4.2.3.2 GEARBOX DISMANTLING (ON BENCH) 1. Remove the magnetic drain plug and drain the gear box oil. 2. Remove the clutch release bearing and clutch release fork. (For procedure refer clutch removal procedure in Clutch section) 3. Loosen and remove clutch housing nuts along with spring and bright washer and separate the clutch housing from the gear box. 4. Loosen and remove the nuts (6 Nos.) and take out the top cover assembly along with the gear shifter linkage. Remove the gasket which is be- tween top cover and rear half. (4x2 & 4x4) NOTE Separate the shifter linkage assembly from the top cover assembly by removing the retainer clip and the cylindrical pin. 5. Remove the staking from the lock nut on end flange assembly with the help of chisel. 6. Lock the flange assembly with the special tool (Part No. 2894 5890 35 17), loosen and remove the end yoke nut by holding it with sprocket (Part No. 2698 5890 41 01) and then pull out the end flange with the help of standard puller. (Only in case of 4X2 version.)