HEXA

ENGINE 95 12. Take out the timing belt. 13. Remove the auto tensioner and replace it with a new one during re-fitment. NOTE  Ensure that every time the timing belt is replaced, auto tensioner is to be replaced with a new one.  Do not remove any of the special tools. Inspection : Inspect the Timing belt for wear, cracks and signs of failures. Replace if required or replace at recommended interval. Inspect tensioner mounting face on cylinder head and idle mounting spacer surface on cylinder block and ensure that the face is not damaged and is clean. G. Fitment of Timing Belt : 1. Ensure Assembly oil pump and water pump are fitted properly. 2. Install Crankshaft pulley on crankshaft front end with woodruff key and Friction plate. 3. Install spacer (for idler) and idler on the block. 4. Rotate Crankshaft to bring piston in cylinder no.1 to TDC position. Lock flywheel in this position using flywheel locking pin (Part no . 2870 5890 06 01 ) . 5. Install FIP gear on pump and tighten the gear in position, with specified torque (6.6±0.5 Kgfm)