HEXA

ENGINE 181 REMOVAL 1. Disconnect electrical connections of brake light switch (1) and brake switch for cruise control (2) (If fitted) . 2. Loosen the mounting nut of brake switch and take out the brake switch by rotating anticlock- wise direction. INSPECTION Disconnect the connector and check the continuity between the following pins. When the pedal is de- pressed there should be connectivity and when it is released to rest position there should not be con- nectivity. Brake Light Switch: Pins 1 and 2 for Brake light circuit. Pins 3 and 4 for Brake signal to EMS circuit Brake switch for Cruise Pins 1 and 3 for Brake pedal signal for cruise con- trol. For switch adjustment details, refer brake section . PIN OUT PIN NO DESCRIPTION 1 Ignition 2 Supply to tail lamp 3 Ignition 4 Signal to EMS BRAKE PEDAL SWITCH (FOR VEHICLES WITH CRUISE CONTROL) PIN NO DESCRIPTION 1 Ignition 2 NC 3 Signal to EMS (Cruise Control) 4 NC REFITMENT 1. Fit the brake light switch on the mounting bracket and tighten its mounting nut. NOTE Refer brake section for brake switch adjustment details.