HEXA

ENGINE 109 The Specified resistance values and calibration details of the Tank unit fuel gauge are given below. Float Position Full - - Half - Empty High Empty Low Usable fuel volume in liters 58 48.5 39 30 21 12 3 Height in mm 152 120 99 80 61 40.5 20.5 Resistance value in Ohms 8 32 51 67 83 103 126 Tolerance in Ohms ±2 ±4 ±4 ±2 ±4 ±2 ±2 R. Tank Pressure Valve (TPV) : REMOVAL : 1. Fold the 2 nd row RH Seat and somersault it to access the in tank pump cut out. 2. Lift the carpet with foam (1) at the cutout. 3. Loosen and remove the four screws of the cutout cover and remove it. 4. Remove the TPV protection cap (1). 5. Loosen the clamp and disconnect the pipe. 6. Remove the TPV from the clamp. CAUTION  Be careful not to damage the vapour line pipe. If found damaged replace it . INSPECTION : 1. Check tank pressure valve for crack or damage. 2. Replace if any damage is found. 3. When air is smoothly blown from the tank unit side it should pass through the valve. 4. Similarly if air is smoothly blown from the open end side it should pass through the valve. 5. If air does not pass through valve in step 2 or hard blows are required in step 3, replace tank pressure valve.