HEXA

ENGINE 171 CONNETCOR DETAILS PIN DETAILS PIN NO DESCRIPTION Pin 1 Power supply Pin 2 Signal Pin 3 Earth REMOVAL 1. Remove engine cover. 2. Disconnect the wiring harness connector from cam shaft position sensor. 3. Remove one mounting bolt of sensor and take out the cam position sensor from its location. INSPECTION 1. Using multimeter measure the voltage across the pins of cam sensor. With ignition ‘ON” voltage between pin 2 & 3 is as below,  4.7 V ( When the flag is not in front of the sensor )  0.6V ( When the Flag is in front of the sensor ) REFITMENT 1. Locate the cam shaft position sensor and fit one mounting bolt and tighten with specified torque. Tightening torque for bolt – 1 Kgfm 2. Connect the wiring harness connector to the cam shaft position sensor. 3. Fit engine cover. CAUTION: Cam Sensor Reset need to be activated in Di- agnostic Tool whenever Cam Sensor is changed or When any of the Timing drive sys- tem components is changed or TDC is reset for some reason like flywheel change etc.