HEXA

SUPPLEMENTARY RESTRAINT SYSTEM (SRS) 27 vehicle fitted with both frontal airbags. The load limit- er fitted inside the retractor unit is basically a torsion bar. Whenever the belt load increases beyond the pre-defined limit, some length of the belt is released due to twisting of the torsion bar. The activation of the load limiter does not depend on signal from the SRS ECU. ON VEHICLE REPAIR REMOVAL 1. Disconnect the battery connection. 2. Loosen and remove the lower mounting bolt of seat belt. 3. Remove lower “B” pillar trim. (For procedure refer “B” pillar trim removal procedure in CAB section.) 4. Remove the garnish of “B” pillar by pulling it out from the floor. 5. Loosen and remove the mounting screws and take out the HVAC duct. 6. Disconnect the electrical connection of RPLL. 7. Loosen and remove the mounting bolt and take out the RPLL assembly. FITMENT For fitment follow reverse procedure of removal.