HEXA

ELECTRICAL 141 8.9.13 INERTIA SWITCH FUNCTION: Inertia switch gives input to BCM for unlocking doors in event of impact. LOCATION: It is located on LH side ‘A’ pillar at inner lower. REMOVAL: 1. Remove the lower A pillar trim. ( Refer body section ) 2. Remove the two mounting screws. 3. Disconnect the electrical connection. 4. Take out the switch. REFITMENT: 1. Fit the inertia switch by tightening its two screws. Tightening torque for screws – 0.6 Kgfm 2. Connect the electrical connection. 3. Fit the A pillar LH lower trim.