HEXA

ELECTRICAL 110 3. Insert the sensor into the ring. Give a gentle pressure (Max. 30N) on the rain light sensor. NOTE:  To avoid the a dust deposit on the silgel after removing the transparent protective cap the rain light sensor must be placed immediately into the securing ring of the windscreen.  Remove ring protection cover from windscreen. The contact surface between rain light sensor & windscreen must be free from pollution as well as dust & dirt.  To avoid the air bubbles as much as possible between the silgel & windscreen, the sensor should be placed into the securing ring so that the silgel can only touch at one points of its outside diameter to the windscreen. Therefore choose the opposing side of the connector socket. 4. Place a rain light sensor fixation clip. 5. Connect the Wiring harness connector. 6. Fit the rain light sensor cover on windscreen. NOTE: If only windshield is damaged during accident & rain light sensor is OK then after removing the RLS from front windscreen replace the SILGEL and use the existing rain light sensor on new windshield (separate part number). Follow proper instructions to replace silgel. FUNCTIONAL DETAILS: 1. AUTO RAIN FUNCTION:  Rain sensor recognizes hitting raindrops on the windshield and releases the wiping processes of the windshield wiper according to number of the raindrops .  Auto rain function get activated if the auto wipe switch ( Part of combination switch ) & ignition is ON.  P1, P2, P3, P4 & P5 have different sensitivity level which is selected by driver when auto wipe function is activated.  P1 is highest sensitivity & P5 is lowest sensitivity.