HEXA

ELECTRICAL 73 8.5 HORN The vehicle is equipped with a horn system consisting of a low tone horn and high tone horn. The horns are operated by pressing the sides of the steering wheel cover (around the Air Bag) with the horn symbol. The horns are activated through a relay located in the engine compartment fuse and relay box. The circuit is protected by a dedicated fuse. The horns are always enabled for safety reasons even with the ignition OFF or the key is extracted. LOCATION: High tone horn is located on RH side of radiator member vertical support and low tone horn is located on LH side of radiator member vertical support. REMOVAL: 1. Open the bonnet. 2. Remove Grill from the bumper by removing the twelve screws on inner side of the bumper. 3. Remove the one mounting bolt of the horn. 4. Disconnect electrical connection. 5. Take out the horn. INSPECTION: Connect the positive terminal of the horn to battery (+) and negative terminal to battery (-). If a clean and sharp sound is heard, then horn is OK. If no sound is heard, check continuity of the horn coil using a multimeter. If the coil is OK, check the settings of the setting screw. Adjust the setting screw till clean and sharp sound is heard. REFITMENT: 1. Align the horn to match mounting hole on assembly vertical support radiator member against weld nut and fit one mounting bolt with a washer. Tightening torque for bolt – 0.95 Kgfm 2. Connect the electrical connection.