HEXA

ELECTRICAL 45 INSPECT STARTER BRUSH Brushes that are worm out, or oil-soaked, should be replaced. Brush Length Check: Unlock the brush holders on the brush plate and check carbon brushes. Minimum allowable length of carbon brushes 4.5mm.If carbon brushes are to short or broken then replace the entire brush plate. STARTER BRUSH HOLDER TEST Check that there is no continuity between the (+) brush holder (A) and (-) brush holder (B). If there is no continuity, replace the brush holder assembly. INSPECT OVERRUNNING CLUTCH 1. Slide the overrunning clutch along the shaft. Replace it if does not slide smoothly. 2. Rotate the overrunning clutch both ways. Does it lock in one direction and rotate smoothly in reverse? If it does not lock in either direction of it locks in both directions, replace it. 3. If the starter drive gear is worn or damaged, replace the overrunning clutch assembly. (The gear is not available separately) Check the condition of the flywheel or torque converter ring gear if the starter drive gear teeth are damaged. CLEANING 1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only. 2. Do not immerse the drive unit in cleaning solvent. The overrun clutch is pre-lubricated at the factory and sol-vent will wash lubrication from the clutch. 3. The drive unit may be cleaned with a brush moistened with cleaning solvent and wiped dry with a cloth.