HEXA

PROPELLER SHAFT 10 B. PROPELLER SHAFT (4X4) I REAR PROPELLER SHAFT REMOVAL 1. Loosen and remove the front mounting bolts from Transfer case. Take out the front end of rear propeller shaft from transfer case. 2. Loosen and remove the mounting nuts (Nos.4) of bearing strap from rear axle. Take out the rear end of propeller shaft from rear axle. FITMENT Before fitment ensure that 1. Splines should slide freely with slight drag from splines shaft seal. Cross should flex and be free from excessive bind. NOTE A slight drag is the most desirable condition on a new cross and bearing kit. Excessive looseness is not desirable and will result in an unbalanced propeller shaft. 2. Mounting Flange should be free from burrs, paint and foreign substances which would not allow proper seating at assembly. 3. While installing and servicing, the system balanced assemblies, the following care should be taken: CAUTION  End yokes must not be rotated from their original position during reassembly.  Self-locking bolts and Nyloc nuts used with bearing straps should not be reused . CAUTION 1. Do not go under the vehicle when the engine is running. 2. Install a support strap when servicing propeller shaft to prevent personal injury. WARNING A serious or fatal injury can occur due to: 1. Lack of proper training. 2. Fail to follow procedures. 3. If proper tools and equipment are not in use. 4. If assembly of propeller shaft components is improper. 5. Use of incomplete propeller shaft components assembly. 6. Use of worn out or damaged propeller shaft components. 7. To avoid this get proper training, learn and follow safe operating procedures, use proper tools and safety equipment’s, use proper components in good condition. For installation proceed in the reverse.