HEXA

FRONT AXLE (4X4) 21 7. Re-position the case in press (Part No. 2894 5890 35 19) and remove side bearing cone from other side in same manner. NOTE It is always preferred to replace side bearings once pulled out. But one can confirm free rolling of bearing and reuse it, if they are defect free. 8. Loosen and remove the ring gear screws and remove the ring gear. 9. If required tap ring gear with a mallet to free it from case. NOTE Discard ring gear screws and replace with new one. Install differential case on axle shaft. 10.Use suitable drift to remove the roll pin retaining cross shaft. 11.Use hammer and punch as shown to remove the cross pin from case. 12.To remove side gears and pinion mate gears, rotate the side gears. This will allow the pinion mate gears to turn to opening of the case. Remove pinion mate gears and spherical washers behind the gears. Lift outside gears and thrust washers. Inspect all parts including the machined surfaces of the case itself. Where necessary, replace all worn parts.