HEXA

FRONT AXLE (4X4) 18 C. TONER RING REMOVAL 1. Remove the stone guard. (For procedure refer stone guard removal in body section.) 2. Remove front wheels. 3. Remove split pin and hold the hub assembly with the hub holder (Part No. 287058903316) . Secure the hub holder tool on the hub assembly by locking with nuts and loosen drive shaft nut. 4. Lift the vehicle in two post lift. 5. Loosen and remove mounting bolts of front brake caliper assembly with carrier and remove the brake caliper assembly. ( For procedure refer Brakes section ). NOTE Don’t remove hydraulic brake line connected to Brake caliper assembly. 6. Disconnect steering rack and pinion OBJ end from stub axle. ( For procedure refer Steering RAP removal section ) 7. Remove front wheel speed sensor ( For procedure refer Brakes - ABS section ) and disconnect the bracket by removing the mounting bolt which is for brake hose from the stub axle assembly. 8. Loosen and remove the mounting nut of ARB (Anti roll bar) link assembly from stub axle. 9. Remove the drive shaft nut which was loosen earlier. 10.Disconnect upper wishbone ball joint . (For procedure refer suspension upper wishbone ball joint removal section) 11.Support the stub axle assembly from below. Disconnect lower wishbone ball joint using puller (Part No. 287058904601) . (For procedure refer suspension lower wishbone ball joint removal section.)