SAFARI STORME MY14

ELECTRICAL 136 HIGH SPEED When HIGH SPEED is selected then the wipers will move continuously across the windshield at high speed. This mode is not controlled by the BCM but will be detected by the state change of the front wiper parking switch input. 2. FRONT WASH: When the front washer switch is pressed, washer fluid is sprayed onto the front windshield. Maximum wash time is 30 seconds to protect the washer fluid motor. If the wiping mode is OFF or INTERMITTENT, wiping will begin 0.5 seconds after washing begins, at LOW SPEED. When washing finishes, the wipers will wipe for 3 more sweeps, before returning to the previous mode. If the wiping mode is FLICK, LOW SPEED or HIGH SPEED, wiping will continue in the same mode. If the mode is changed from LOW SPEED or HIGH SPEED to OFF or INTERMITTENT during a wash, the wipers will wipe for 3 more sweeps at the end of washing before changing to the new mode. 3. DRIP WIPE After a front wash operation, the front wiper should operate for one sweep after a time period to remove any drips from the windscreen. If the wiping mode is OFF, a single wipe should be performed 5 seconds after the wiper has returned to park at the end of the wash event. If the wiping mode is INTERMITTENT and the time period is 6 seconds or less, the INTERMITTENT wiping should continue as normal. For any other time period a single wipe should be performed 5 seconds after the wiper has returned to park at the end of the wash event. INTERMITTENT mode should then continue at the set interval. The interval timer should be reset to zero after the single drip wipe. If the wiping mode is LOW SPEED or HIGH SPEED or continuous FLICK wipe then Drip Wipe is not active. NOTE: When the wipers are ‘ON’, the wiping mode is ‘ON’. If the wipers are ‘OFF’, the wiping mode is ‘OFF’.                              