SAFARI STORME MY14

ELECTRICAL 135 ELECTRICAL 1. FRONT WIPE: There are five wiping modes of Front wiper:  OFF  FLICK WIPE ( not controlled by BCM )  INTERMITTENT ( controlled by BCM )  LOW SPEED ( not controlled by BCM )  HIGH SPEED ( not controlled by BCM ) The wiper park position input switch is used to detect when the wiper blade is at the bottom of the wind screen. OFF In this state the front wipers should be in the park position. ( Indicated by the wiper park switch being active ) When the wiper mode is changed from FLICK WIPE, INTERMITTENT, LOW SPEED, or HIGH SPEED to OFF the wiper continues the current wipe operation until the park switch indicates the wiper is in the park position. FLICK WIPE When FLICK WIPE is selected, the wipers move once across the windshield at low speed and return to the park position. If FLICK WIPE is permanently selected ( switch held on ), then the wipers will move continuously across the windshield at low speed. This mode is not controlled by the BCM but will be detected as LOW SPEED by the state change of the front wiper parking switch input. INTERMITTENT WIPE: On vehicles with variable resistor Combi switch installed the interval between consecutive intermittent wipes shall be dependent on the position of the interval wiper delay setting. There are 5 settings for the variable resistor, of which setting P1 shall be the shortest interval, and setting P5 shall be the longest interval. If no delay input is detected (during open circuit error condition) or the variable resistor is not fitted, a default setting of P2 will be used. When the wipers are in INTERMITTENT mode, if a shorter delay period is selected ( i.e . wiping to occur more often ), an “immediate wipe” will be performed with wiping continuing at the new, shorter interval selected. When a longer interval is selected, the delay time for the new interval is used to determine when the next wipe is initiated. The delay time is measured from the end of the last wipe, not from the time that the interval was changed. Delay Table: LOW SPEED When LOW SPEED is selected then the wipers will move continuously across the windshield at low speed. This mode is not controlled by the BCM but will be detected by the state change of the front wiper parking switch input.