SAFARI STORME MY14

ELECTRICAL 71 ELECTRICAL NOTE: Co-driver side wiper ARM and blade assembly should be aligned with marking provided on the black band of the windshield glass. 3.Fit mounting nut and tighten with specified torque. Tightening toque for Nut: 2.5 Kgm 4.Fit the rubber cover. 5.Check the correct operation of wiper. 8.9.3.3 REAR WIPER ARM AND BLADE REMOVAL: 1.Lift the wiper arm cover to access the wiper arm mounting nut on wiper shaft and remove the mounting nut. 2. Lift the wiper arm and blade assembly vertically to take out the wiper arm easily against spring force of wiper arm and take out the wiper arm and blade assembly from wiper motor shaft. INSPECTION: Inspect wiper blade rubber for any cut. If found, replace the wiper blade assembly. REFITMENT: 1.Before fitting the wiper arm bring the wiper motor to the parking position. This can be done by switching ON the Ignition, and run the rear wiper motor end then switch OFF the rear wiper motor only. NOTE: Switch OFF the Ignition only after the motor has stopped. 2.Insert the arm and blade assembly on wiper motor shaft by locating it on the splines. 3.Place arm and blade assembly on parking position. As shown in the below figure. 4.Fit one mounting nut and tight with specified torque, and push the wiper arm cover. Tightening torque for nut- 1 Kgm