SAFARI STORME MY14

Rear Axle 30 Install Inboard Oil Seal on the seal pressing dolly. Apply the uniform sealant layer inside the oil seal. Locate into the Bore & Press fit oil seal with nylon hammer. Note: Use an bond A-676 or 3M sealant. Note: Ensure that the distance of the flange face to Shaft guide face must be 44+ 0.25 Assemble Shaft Assembly In Banjo: Take the Axle shaft Assembly check the axle shaft as per the check point mentioned in axle shaft section. Insert the axle shaft (splined end) through shaft guide & push axle shaft in as far as possible while aligning the brake assembly bolts with banjo beam flange holes. Engage the splines of axle shaft in the carrier section & push further. Install the nut & tighten it manually & torque them (Torque 75-85NM) Ensure correct shaft (e.g. LH & RH side shaft) inserted on correct side Note: LH side axle shaft can be identified by Groove Mark on the spigot face. Install the break drum as shown in the figure