SAFARI STORME MY14

Rear Axle 26 case. To prevent pack from falling out of the case, it will be necessary to hold them in place by hand while repositioning case on bench. Reposition case on bench as shown. Assemble the adapter plate into the side gear. Apply a small amount of grease into the centering hole of the step plate. Assemble the other clutch pack and side gear as shown. Make sure the clutch pack stays assembled to the side gear spines, and that the retainer clips are completely seated into the pockets of the case. Hold the clutch pack in position and insert the threaded adapter into top side gear, insert forcing screw. Tighten forcing screw into bottom plate. This will hold both clutch packs in position. With tools assembled into the case, position case onto the axle shaft by aligning the splines of the side gear with those of the shaft. Loosen forcing screw slightly. Assemble both pinion mate gears as shown. Hold gears in position by hand. While holding gears in place, insert turning bar into case. Pull on bar to rotate case allowing gears to turn. Make absolutely sure that the holes of the pinion mate are in alignment with holes of the case. Pre-lubricate spherical washers. Torque forcing screw until it is tight. This will collapse the Belleville plates and allow clearance between gears. Assemble spherical washers into case. Use a small screwdriver to push washers into place. Remove tools & assemble cross pin shaft & drive in shaft with hammer. Use the drift to replace the roll pin that retains the cross pin shaft. When roll