SAFARI STORME MY14

FRONT AXLE (4X4) 47 FRONT AXLE (4X4)  Pin B and Chassis ground: Measured voltage = 0 Volts  Pin D and Chassis ground: Measured voltage = Battery voltage (8 to 12 V)  Pin A and Chassis ground: Measured voltage = 4 to Battery voltage. If the voltage is out of the above mentioned range, check for any short circuits or open circuits. Recon- nect the connector after rectifying the problem ASSEMBLY 1. Ensure cleanliness of disconnect housing cover, shift fork, shaft shift fork and spring. NOTE Discard the old spring and use new at the time of assembly. 2. Insert the spring and shift fork through the dis- connect cover window while aligning the spring into bore in the cover and sitting in the slit of shift fork. NOTE Orientation of the shift fork is important and it should be maintained properly. 3. Insert the shaft shift fork in the opposite way of removal, ensuring that it passes through shift fork as well as the spring. Press the shaft shift fork in the bore by hand. 4. Install the electrical motor on cover assembly and tighten the screw with specified torque. NOTE Ensure that the “O” ring on the electrical motor is not cracked or damaged. If so replace the “O” ring.